SNMP OID Classifications missing for named Pali Aulto Firewall typesDescriptionPalo Alto firewall are being created with class "IP Firewall" instead of "Palo Alto Firewall Device". The reason seems to be the System OID Classifications are missing from the SNMP Clarification, see attached image. The same problem seems to exist for Juniper and Fortinet firewalls. The end result sees to be that basic identification is performed but the Next Generation Palo Alto Firewall pattern is not launched. Steps to Reproduce Search for OID "1.3.6.1.4.1.25461.2.3.38" in OIDS table and check if you can see the table name as "Ip firewall" and classifier as "firewall". If that the case please correct the SNMP OID classifier value to the palo Firewall classification. Change the SNMP OID record to point to Palo Classifier.Execute the Discovery again for the device and see if this showing the identification error as below, "Identification Engine: Discovery status is FAILURE, CI type cmdb_ci_firewall_device_palo_alto cannot be created since there are no attributes defined."WorkaroundAdd a step 11. Populate name if the PaloAltoFirewallTableTemp is empty(attached screenshot)Add step 19. Filter Palo Alto Device with empty serial to filter if there are any empty serial number in the cmdb_ci_firewall_device_palo_alto table (attached screenshot)Go to MakeAndModelJS script include and make it accessible from all scope (this is already fixed in Paris and in Orlando patch). Update Set(Attached in the PRB-PRB1428376):- sa_pattern_8949fcb4db2814d47faf89584b961975.xmlRelated Problem: PRB1428376