[Class Manager] UI issue not showing Identification Rule upon initial visitDescriptionUpon first visit to "IP Network" class and clicking on Identification, it doesn't show any rules. However, then search for IP Switch, click on Identification, and finally return back to IP Network and click on Identification again and it then shows the rules. Steps to Reproduce 1. On Washington P9, go to Class Manager.2. Open IP Network.3. Click on Identification.RESULT: Notice it's empty.4. Now search for and navigate to IP Switch.5. Click on Identification.RESULT: Notice it's populated with cards.6. Now search for and go back to IP Network.7. Click Identification again.RESULT: Notice the cards are now populated.Side note: Not sure if these are the correct cards or not though.WorkaroundFor now, the only workaround at this point is what's described about bringing up another class first and then returning.Related Problem: PRB1862262