Flow Designer - Look up record - Don't fail on error is not workingDescriptionLook Up Record step is failing with an error of "No Record found" even though "Don't fail on error" is set to true.However, when we make small changes and save/activate the Subflow resolves the issue but whenever we make changes again, this issue occurs again.Steps to Reproduce 1. Navigate to Flow Designer >> Actions >> 'Look Up Record'[Please NOTE, 'Don't fail on error' is not setting any value in Lookup Record step]2. Click on Test >> Select table which is empty/no data (create new empty table if couldn't find any table with no data)3. Do not select 'Don't fail on error' checkbox for the first time >> Run Test 4. Observe, it will be failed with error as 'No Record Found'5. Repeat the same process but this time SELECT 'Don't fail on error' checkbox >> Run Test 6. Observe, it will be failed with error as 'No Record Found'However, it should not fail if we select 'Don't fail on error'.Workaround Load the attached sys_hub_action_type_definition_b93f42810b30030085c083eb37673a63.xmlRelated Problem: PRB1475636