SAML properties prompts to upgrade even though Multiple Provider Single Sign-On Installer is already installedIssue You will recognise this issue by the following prompt in the SAML 2.0 properties page However the Multi Provider SSO plugin is already installed On Checking the SAML 2.0 Installation Exits SAML2LogoutSAML2Logout_update1SAML2SingleSignonSAML2SingleSignon_update1 It is observed that they are still active CauseIf there is an existing SAML2 Update1 configuration when the Multi Provider SSO plugin is installed the existing IdP details are migrated into the plugin. This will create a SAML 2 Migrated IdP record within Multi Provider SSO. However we do not automatically enable this in order to allow verification of the configuration prior to switching over to the new plugin. Until the Multi Provider SSO plugin is enabled you are still using the SAML 2 configuration and will see this message as a reminder.ResolutionTo activate the Multi Provider SSO plugin , check the relevant box in the Properties page Checking this will deactivate the SAML 2 installation exits,IdP etc,remove the SAML2 application from the navigatoractivate the Multiple Provider SSO installation exits, IdP etc NOTE: If you have changed your IdP configuration since the Multi Provider SSO plugin was installed then the migrated IdP record will be incorrect. You can run a repair on the plugin installation to have a new migrated IdP record created Related LinksFor more information, see the following Documentation topics: External single sign-on (SSO) Installation Exits Changes to SAML 2.0 and digest token configuration