How to setup the default search context for Agent Assist in Agent WorkspaceSummaryLet's take the incident table for the article. By default, the short description keywords (that are existing or dynamically provided by the user) are searched to show any relevant existing data. The existing data is searched for in the incident, knowledge, and catalog items table. (you can add other tables as well) Agent Assist works in a similar way, how the Contextual Search works in native UI. The following steps will show how to set the default search context. Navigate to Contextual Search > Table Configuration.Open the configuration for the specific table, defined for Workspace.Validate the Search Fields related list to check, short_desciption is defined as the field.Click the Search context reference field, and open the record.Click the Searcher reference field, and validate the tables are included.Navigate to Additional Resource Configurations related list.Validate if the resources are active.Validate if the Default search is set to true for any of the configurations. (This is where the agent assist will not show the correct search results)Now go the Search context record that was opened in Step 4.Click on 'Set As Default' UI Action.Now go to the additional resource configuration tab, and select the entry that you want to be the default search.Click on the Description hyperlink, and open the record.Click on 'Set As Default' UI Action here as well.Under the Additional Resource Configurations related list, click on the Search resource configuration hyperlink for the same record, and validate the filter conditions used. Now go back to Workspace, and create a new Incident. To test, give a short description that satisfies the condition defined in Step 14. You would see the relevant data.ReleaseAll supported releasesRelated LinksPlease refer to this KB article as well Agent Workspace - How to configure Agent Assist for a table