[Discovery-Shazzam] Warning "The following protocols have been disabled via the Configuration Console and will not be scanned by Shazzam: XXXXX" - Support and Troubleshooting

[Discovery-Shazzam] Warning "The following protocols have been disabled via the Configuration Console and will not be scanned by Shazzam: XXXXX" Issue  Symptoms We may encounter some warning messages as below in the discovery log within Discovery Status.

""

The following protocols have been disabled via the Configuration Console and will not be scanned by Shazzam: XXXXX

""

XXXXX - wbem, SSH, WMI, etc..

Release All Releases...

Cause When we initiate the discovery schedule, it will check for the protocols that are deactivated within the Protocol Categories. If it finds any protocol category is deactivated then it will throw Warning message as above.

Resolution Method #1 : (Using the Configuration Console)

Open Application Navigator >> Discovery Definition >> Configuration Console Under the Devices section, enable the related device protocol.

Reference: Discovery Configuration Console

Method # 2: (Using the table entries)

Check the Protocol Categories table list and see if any protocol is deactivated. Table: discovery_category_protocol If you would like to enable that category, activate them else if you don't want them to be discovered, you can ignore the messages.